Polycom 52PFL7403D Flat Panel Television User Manual


 
ENGLISHFRANÇAISEESPAÑOL
EN-27
Change your TV installation6.
The first time you switch on your TV you select the language for the TV
menus and make basic choices for picture and sound settings. Use this
chapter to reinstall the TV, to set preferences in the TV menus, or to
tune new TV channels.
6.1 Select your menu language
Press1. MENU on the remote control and select Installation >
Language.
Language
English
Francais
Espanol
Installation
TV menu
Language
Channels
Preferences
Source labels
Reset A V settings
Current software info
Clock
Select a language and press 2. OK to confirm your choice.
Press 3. Í to return to the Installation menu.
6.2 Set your location to home
You can set the location of your TV to Home or Retail store.
Choosing Home gives you full flexibility to change predefined settings
for picture and sound.
Press1. MENU on the remote control and select Installation >
Preferences > Location.
Select 2. Home and press OK to confirm your choice.
Press 3. Í to return to the Installation menu.
6.3 Tune channels automatically
This section describes how to search for and store channels
automatically. Before you tune channels, ensure that you are registered
with your cable TV provider and that your equipment is correctly
connected.
Press1. MENU on the remote control and select Installation >
Channels>Autoprogram>StartNow.
Autoprogram
Start Now
Autoprogram
Weak channel installation
Installation mode
Uninstall channels
Channels
TV menu Installation
Press 2. OK to start the installation.
If you run Autoprogram when you have locked channels, a
message appears asking to enter your PIN code. Enter your PIN
code in order to complete the installation.
If you have forgotten your PIN, reset it as described in Set or change
your PIN on page 19.
Select 3. Cable or Antenna and press OK.
When • Antenna is selected, the TV detects antenna signals. It
searches for NTSC and ATSC channels available in your area.
When • Cable is selected, the TV detects signals supplied by cable.
It searches for NTSC, ATSC, and QAM modulated channels
available in your area.
System searching. Please wait...
Analog channels found: 0
Digital channels found: 0
TV installation
When autoprogramming is complete, this message appears
"Channel search completed".
Follow the on-screen instructions to complete the installation.4.
6.4 Optimizethesignalqualityfromyourantenna
You can optimize your signal quality by tuning in ATSC channels with
weak signals, and adjusting the antenna.
Press1. MENU on the remote control and select Installation >
Channels > Installation mode.
Select 2. Antenna and press Í to confirm your choice.
Press 3. Î and Æ to enter Weak channel installation.
Highlight a channel from the list of TV channels and press the green 4.
color button on the remote control.
The signal strength for the channel is displayed.
Adjust your antenna to maximize the signal strength.5.
Press 6. MENU to exit.