Filter
Top Products
English
103
Problem (USB/HDMI) Solution
Troubleshooting (continued)
The contents of the USB
ash drive cannot be read.
Slow operation of the
USB ash drive.
The connected card
reader/ ash drive is not
detected. The message
‘USB Hub is not
supported’ appears.
No sound on HDMI
connection.
No picture on HDMI
connection.
Picture output through
the HDMI connection
does not look good.
– The USB ash drive format is not compatible with the
system.
– Drive is formatted with a different le system which is
not supported by this DVD recorder (e.g., NTFS).
– Large le size or high memory USB ash drive takes
longer time to read and display on the TV.
– This recorder only supports Mass Storage Class (MSC)
devices. Not all card readers/ ash drives implement this
standard. Please use another device.
– You may not hear any sound from the HDMI output if
the connected device is non-HDCP compliant or only
DVI-compatible.
– It is not possible to output SACD or copy-controlled
DVD-Audio sources from the HDMI connection.
– Make sure that you have activated this recorder as the
HDMI input in the settings for the device you are using.
Press OPTIONS on the remote control, go to Video
setting and set the { Active Video Output } to
{ HDMI Output }.
– HDMI connection can only be made to HDMI-equipped
devices with HDCP (High Bandwidth Digital Content
Protection). If you wish to connect to a DVI connector
(equipped with HDCP), you will need a separate adaptor
(DVI to HDMI).
– Make sure the resolution of this recorder matches the
device you have connected using the HDMI. See HDMI
setting.
– Check if the HDMI cable is faulty. Replace a new HDMI
cable.
– When connecting to a non-HDCP compliant TV, the
HDCP warning message will appear only on the analogue
video output.
– Change the HDMI video resolution as follows:
1) Press OPTIONS on your remote control.
2) Select { Settings } > { Video Output } > { HDMI } in
the menu.
3) Select { Manual } > { 480p/560p }.