Filter
Top Products
1) Select on-screen menu language
2) Select the signal that is connected to the
CABLE/ANTENNA input jack
Press (right key) to access the choices (Cable-
Antenna or Antenna only) and then press to
highlight “Done” and press OK.
Note: turn on the cable box or satellite receiver before
completing this step.
3) Channel search
Automatic channel search starts. When the search
reaches 100%, press OK (the channel list appears).
If the channel list does not appear, check the
ANTENNA/CABLE input jack to make sure the cable
is connected properly.
7
EN
Initial setup
8
EN
Initial setup
Turn on the TV and DVD recorder
1. Turn on the DVD recorder by pressing ON/STANDBY.
2. Turn on the TV and select the input mode connected with the DVD recorder output signal. To do so,
you usually press the AV button on the TV remote control until you get to the video input channel
that matches how the DVD recorder is connected to the TV. When you are on the right channel,
you can see the DVD recorder menu for language selection (see below).
Note: since access to a TV’s video input channel varies from one manufacturer to the next, it is difficult to provide
specific instructions for your particular brand. Please consult the user manual of your TV.
Interactive setup
•Use the remote control to follow the on-screen instructions. Use navigation keys ( ) to
move the on-screen highlight in the corresponding directions on the screen.
• Press OK to select a highlighted item.
Note: You can access the setup screen from the player menu. If you move, get a different program provider for TV
shows, or change your connections, you will need to complete the interactive setup again.
4) Channel list
The channel list contains the channels you tune to
when you press CH+ or CH– on the remote control.
From the channel list screen, you can delete
channels you rarely watch. You will still be able to
tune to the “deleted” channels directly by using the
number buttons, but the DVD recorder will not
tune to a channel when you press CH+ or CH–.
Use the navigation keys ( ) to scroll
through the channels. A checkmark in the box next
to the channel means it has been stored in the
channel list. Highlight the channel and press OK to
check or uncheck the box. You can also label
channels by pressing INFO.
To skip editing the channel list, press STOP.
5) Select your time zone
6) Daylight saving time
If you select “Yes”, the recorder’s internal clock will
automatically advance the time by 1 hour in the
spring and set the clock back by 1 hour in the fall.
DRC8030_EN 8/15/06 10:30 AM Page 14