Filter
Top Products
:S. Connect antenna or cable-TV system.
Most antenna or cable-TV systems can be connected as
show here.
Back
of 13/
t
/
/
/
f
/
/
i
/
/
Incoming Cable from Antenna or
Csble-TV System
ANTI
CONVERTER
m
• Details for connecting a home antenna to your TV are on
page 32.
• Details for connecting a cable-TV system to your TV
are on pages 33-34.
• Details for connecting a VCR to your TV are on
pages 37-38.
9. AutoProgram the TV's
channel memory.
To start the TV autoprogramming
itself, press the MENU button
repeatedly to select SETUP MENU
8. Converge Colors if Necessary.
If you notice colored rings or halos around objects in the
picture, you may need to converge the colors. Over a period
of time, the picture tubes can drift out of alignment due to
normal bumps and vibrations or moving the "IV. Details for
converging the colors are on page 15.
MENU
Button
- Button / db _ _. I ÷ Button
andthenpress + todisplaythe setupfunctions. Repeatedly
press MENU again to select theAUTOPROGRAM function,
and then press +. Details are on page 24.
6. Attach power cord.
First attach the flat end of the power cord completely into the
connector on the back of your TV, and then plug the other
end into a wall outlet.
7. Turn on TV, adjust the volume, and select a channel.
• Press the TV button on the
remote to turn on the TV.
When using the remote,
remember to point it at the
front of the TV.
• Press the VOLUME up or
down button to adjust the
volume to a desired level.
• Press the CHANNEL up or
13/
_J_ Button
_=_ _ CHANNEL
Number-- _ -_ Buttons
Buttons _ _ VOLUME
down button to select the next channel in memory. You can
also press two number buttons to select a channel. To select
a 3-digit cable channel (up to channel 128), press and hold
number button 1 until 1-- appears on the screen. Then press
the other two numbers. Channels 2-13 were programmed
into the channel memory for you at the factory, so pressing
CHANNEL up or down stops at these channels only. When
you start the AutoProgramming feature (described in step 9),
your set will automatically scan through all channels and
place only the active channels for your area into its channel
memory.
• Details about using the remote are on page 9-13.
._u_ _ Labe!
_VldeoM_i_ parentalC_: Off
@¢xr_ Menu _ O..,hanCtrl:Normal
You can also add and erase channels from memory as desired.
Press MENU repeatedly to select the SETUP MENU, then
press + to display the setup, functions.
Press MENU repeatedly to select (highlight) the CHAN MEM
function. Select the desired channel number by pressing the
CHANNEL up or down button or by pressing the two
corresponding number buttons.
Ctrl:.Off .
•._'CtuanGirl: Normal
_-_Autowo_ram ....
_._an Label
_iParentalGirl: Off
'iDhanCtrl:Normal
Then press + to add a channel, or press - to erase a channel.
Details are on page 24.
4