Filter
Top Products
25
The Menu System
ADJUSTING THE PICTURE SETTINGS IN MEMORY MODE
In MEMORY mode, you can set and save the following picture
adjustments:
CONTRAST – Changes the picture’s contrast (between light and dark).
BLACK LEVEL – Makes the picture lighter or darker.
SHARPNESS – Changes the picture’s sharpness.
COLOR – Changes color density (video input only).
TINT – Changes picture tint (video input only).
COLOR TEMP – Changes the color tone.
NOISE REDUCE – (noise reduction)– Removes extraneous information
from the signal to make the picture clearer.
NOTE: Only the contrast and brightness can be adjusted when a computer
signal is used.
Once you have selected MEMORY mode, you can adjust the picture
settings. For example, to change the contrast setting:
1. Use the ▲ or ▼ button to highlight the CONTRAST option. Press the
button to select it. The CONTRAST window appears. Use and
buttons to adjust the contrast.
NOTE: If you don’t push the or button within 5 seconds, the
current setting is accepted and the previous screen reappears.
2. Once the contrast is adjusted, press OK or MENU. The contrast is set
and you are returned to the PICTURE QUALITY menu.
3. Use the same procedure to adjust the black level and sharpness
settings.
4. When you are finished adjusting the picture settings, press GO BACK
to return to the main menu or press CLEAR to exit the menu system.
If the “CONTROL NOT AVAILABLE” message appears when you are
trying to change the picture settings, make sure the preset mode is set to
MEMORY. You can only change picture settings in MEMORY mode. The
other modes are pre-set and can’t be changed.
CONTRAST
This is the PICTURE QUALITY menu with the
PRESETS option highlighted.
This is the CONTRAST screen.
: MEMORY
: COOL
: LOW
PICTURE QUALITY
SEL.
ADJ.
CONTRAST
BLACK LEVEL
SHARPNESS
COLOR
TINT
PRESETS
COLOR TEMP.
NOISE REDUCE
R
G
RETURN