Filter
Top Products
10
Setting Up the VCR
SAT SETUP
The VCR will now
receive all signals
from the SAT receiver
on channel 03.
Press MENU to continue
5. Press MENU and enter the code for your digital satellite
receiver from the Satellite Receiver Code List.
SAT SETUP
Enter the code for your
SAT receiver from the
list in your User's
Manual
--
Press MENU to cancel
6. Turn on your satellite receiver and tune it to channel
100 and then press MENU. Follow the on-screen
directions.
SAT SETUP
Please turn on your
SAT Receiver and tune
it to channel 100.
Press MENU to continue
Once you have completed the setup, the VCR confirms
the satellite receiver setup is completed or canceled.
Cable Box Setup
This setup applies only when all channels are received
through the cable box. There are two steps:
• The first sets up the VCR for the output channel of the
cable box signal.
• The second sets up the VCR for a remote-controllable
cable box so the VCR can control the cable box by
changing channels for timer or VCR Plus+ system
recordings. Position the remote-controllable cable box
above the VCR as shown
in the Connections section.
This VCR may not control all models
of the brands that are shown.
Satellite Receiver Codes
Dishnet (Echo) ............................. 78
GE........................................... 00, 01
Hughes Network......................... 77
Panasonic .................................... 75
Primestar ..................................... 76
ProScan .................................. 00, 01
RCA ........................................ 00, 01
Sony ............................................. 72
Toshiba ........................................ 73