Filter
Top Products
13
7. The Autosearch sends the next code in the list every three
seconds. The current code being sent is displayed in the upper
right-hand corner.
8. To speed up the Autosearch, you can manually override the
process and temporarily speed it up by pressing the normal
search keys (CH+, CH-, ON•OFF, LCD UP and DOWN
ARROW) in both forward and reverse directions.
9. Once the component to be controlled responds to the
commands, press and release the LCD OK key to save the
code. After you install its code, all key labels and any
previously Learned commands will be reset.
Note: If your component responds to the command, and the
RCU1010RF sends the next code before you have a chance to
press and release the LCD OK key, you can backtrack through
the Code List by pressing CH- or the LCD DOWN ARROW.
You can change the direction to forward once again by
pressing the ON•OFF, CH+, or LCD UP ARROW keys.
10. After pressing the LCD OK key in step 9, the LCD displays the
Code Search Mode? Screen. Code Autosearch is now complete.
To exit the Setup Mode, press and release the LCD EXIT key,
followed by the LCD OK key on the Exit Setup Screen.
Code Identification allows you to find out what code is currently
programmed in the remote under a given mode (TV, VCR, DVD, etc.).
To find the currently programmed code, follow these steps:
Code Identification
1. Press and release the SETUP key. The last active screen that
was displayed appears.
2. Press and hold any LCD component key. The top right corner
of the LCD touchscreen shows the current code programmed
for that component.
Code Identification Chart
TV CODE
Enter your codes here for easy reference:
VCR CODE
SAT CODE
DVD CODE
AUDIO 1
Tuner
❒
CD
❒
AMP
❒
Tape
❒
✓
AUDIO 2
Tuner
❒
CD
❒
AMP
❒
Tape
❒
✓
AUDIO 3
Tuner
❒
CD
❒
AMP
❒
Tape
❒
✓
AUDIO 4
Tuner
❒
CD
❒
AMP
❒
Tape
❒
✓
AUX component:______
NOTE: Cable Mode is the default for AUX.
(Also use for PVR/DVR)
RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 13