Filter
Top Products
6
Battery Information
Your RCU1010RF Universal Learning Remote with Touchscreen and Built-in RF Transmitter requires
four AAA alkaline batteries (sold separately).
Battery Installation
To install the batteries in the remote:
1. Turn the unit over, push on the tab and slide the cover down.
2. Insert the batteries, matching the batteries to the (+) and (-) marks inside the battery case.
3. Slide the battery cover back into place.
Battery Saver
Your RCU1010RF saves battery power by automatically turning off if any key is pressed for more
than 30 seconds. This saves your batteries should your remote get stuck in a place where the keys
remain depressed, such as under a book or between the sofa cushions.
Code Saver
With the RCU1010RF, you don’t have to worry about losing programmed information when
you change batteries. All programmed parameters are retained indefinitely in the event of
battery replacement.
Power-on Default
When you replace batteries, your RCU1010RF remote always powers on in the TV Mode. If your
TV, VCR or satellite receiver is an RCA, ProScan or GE brand, you may not even need to set
up the RCU1010RF to control it. In these instances, the remote should work as soon as the
batteries are installed.
RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 6