Filter
Top Products
20
Your RCU1010RF’s SmartMacro
SM
feature allows you to perform a series of sequential commands with
one keypress. A SmartMacro
SM
learns any sequence of original remote commands. A total of 20 Learned
commands can be stored under each of the nine available LCD Macro keys. If you program all 20 keys
into a SmartMacro, the Macro is automatically stored after the twentieth Learned command is completed.
The sequence of commands you want a SmartMacro to execute must be programmed in correct
sequential order. Any sequence of commands that you regularly perform can be programmed as
a SmartMacro and reduced to a single keypress. You cannot program a Macro within a Macro.
Program a SmartMacro
Example of Programming a Macro
1. Turn on the TV and set it to channel 3.
2. Turn on the satellite receiver and set it to channel 57.
3. Turn on the VCR.
4. Now you’re ready to record your favorite satellite program with just a keypress.
SmartMacro
SM
Key Operations
To program a SmartMacro, follow these steps:
1. Gather all your original remotes that contain functions
you would like to add to a SmartMacro.
2. Place the first original remote in the Learning position (see
Learning Tips section on pg. 17). Point the top of the original
remote at the base of the RCU1010RF so the IR LED on the
original remote is in line with the RCU1010RF Learn sensor,
located at the bottom of the remote. The remotes should be
positioned 2-3 inches apart.
3. If the original remote is a universal remote, you must press
the component key on that remote to select the desired mode
before proceeding with programming a SmartMacro. For
example, pressing the VCR key on your original universal
remote will allow your RCU1010RF to program a SmartMacro
using that component mode. If the original remote is a dedicated
remote, e.g., a DVD remote only, this step is not needed.
4. Press and hold the SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
5. Release the SETUP key.
6. Press and release the LCD MACRO Key. The Set SmartMacro?
Screen is displayed.
7. Press and release the LCD OK key.
8. The touchscreen now displays the SmartMacro Key? Screen.
Press and release the digit key under which you want to store
the SmartMacro (from 1-9).
9. The touchscreen now shows the S-MacroX Learn? Screen.
Press and release the LCD LEARN key.
10. The S-Macro X Learning Screen now appears on the
touchscreen. Press and hold the key on the original remote
until the LED indicator light on the RCU1010RF blinks once.
This process takes 2-3 seconds to complete.
Note: If there is a problem during the Learning process,
the S-Macro X Error Screen is displayed for three seconds
but remains in the SmartMacro routine and returns to the
S-Macro X Learning Screen. If no Learned command is
detected, the RCU1010RF will timeout after 30 seconds.
11. Release the original remote key.
RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 20