Filter
Top Products
Operating Precautions
To reduce the risk of fire, electric shock and injury to persons, you should follow basic safety
precautions when using your remote control signal sender, including:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug product from the wall outlet before cleaning. Use a damp cloth for cleaning. Do not use
liquid cleaners or aerosol cleaners.
4. Do not use product near a bathtub, washbowl, sink, laundry tub, in a wet basement, in or near
a swimming pool, or near any other water source.
5. Do not place product on an unstable cart, stand or table. It may fall, causing serious damage
to the product.
6. The product should be operated only from the type of power source indicated on the marking
label. If you are not sure of the type of power supply to your home or building, consult your
dealer or local power company.
7. To reduce the risk of electric shock, do not disassemble the product. Take it to a qualified
serviceperson when service or repair work is required. Opening and removing covers may expose
you to dangerous voltages or other risks and also voids the warranty. Incorrect reassembly can
cause electric shock when the product is subsequently used.
8. Unplug product from the wall outlet and refer servicing to qualified service personnel under the
following conditions:
a. The plug is damaged.
b. Liquid has been spilled into the product.
c. The product has been exposed to rain or water.
d. The product does not operate normally when you are following the operating instructions.
e. The product has been dropped or the cabinet has been damaged.
f. The product exhibits a distinct change in performance.
9. No repairs to the unit should be attempted by the customer.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
2. THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and, if not installed and used properly—that is, in strict
accordance with the manufacturer’s instructions—it may cause interference to radio and television reception. It has
been type tested and found to comply with the limits for remote control devices in accordance with the specifications
in Sub-Parts B and C of Part 15 of FCC Rules, which are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio and television reception, which can be determined by
unplugging the equipment, try to correct the interference by one or more of the following measures:
• Reorient the antenna of the radio/TV experiencing the interference.
• Relocate the equipment with respect to the radio/TV.
• Move the equipment away from the radio/TV.
• Plug the equipment into an outlet on a different electrical circuit from the radio/TV experiencing the interference.
• If necessary, consult your local dealer for additional suggestions.
NOTE: MODIFICATIONS TO THIS PRODUCT WILL VOID THE USER’S AUTHORITY TO OPERATE THIS EQUIPMENT.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
2
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 2