Filter
Top Products
Getting started
9ENGLISH
Table installation Wall mounting
30 cmSpace
10 cm
Space
80 cmSpace
10 cmSpace
80 cmSpace
10 cmSpace
10 cm
Space
10 cm
Space
Installation
D Two persons are required to remove the plasma display from the packing. Never lift the display alone.
Any attempt to lift the display alone will pose a risk to your health.
D Place the display on a stable, horizontal base. The base must be solid and capable of bearing the load.
D Before installing it, make sure that the display is switched off and that the mains cable and signal cable
are unplugged.
Wall mounting
D The plasma display screen may be mounted on vertical walls only.
D Before mounting it check whether the loadbearing capacity of the wall is suitable for 3-times the weight
of the plasma display screen (for the weight see page 25 ”Technical Specifications”). If in doubt, seek
the advice of a qualified installer.
D Before installing it, make sure that the display is switched off and that the mains cable and signal cable
are unplugged.
D Two people are required to mount the display screen on the wall.
. Turn the plasma display screen so that the front side
(screen) is pointing downwards and place it on a comple-
tely flat and firm surface.
. A Revox table foot is optional available.
. Fit the 2 fastening hooks (rawl plugs and fastening hooks
arenotincludedintheitemssupplied)horizontallyandwith
the appropriate distance between them (for this distance
see drilling template in the accessories pack) to the wall.
The fasteningmaterialmustbe designed for3-ti-
mes the weight of the plasma display screen. If
necessary, please consult a qualified installer.
. Position the plasma display screen so that the fastening
hookscanbeintroducedintotheopeningsprovidedforthis
purpose on the rear side of the appliance.
ENGLISH
Holes for
rackets
Screws from
the table foot
Optional: Revox table foot