Filter
Top Products
General operation
19ENGLISH
Television mode
The display is in standby mode.
. To switch on, press one of the numeric buttons [0...9] or the [TV] button on the remote control.
Then the television channel last selected (programme number) appears on screen.
If the option <SET UP ' DISPLAY SOURCE INFO> is set to ”On”, the following info window for signal source is displayed for
approx. 5 seconds
If the option <SET UP ⇒ DISPLAY SOURCE
INFO> is set to ”On”, the following info window for
signal source is displayed for approx. 5 seconds -
see the drawing at the left side.
. Pressthe[ P
Y ]or[PB ]buttontoincreaseorreducethechannelnumberinsingleincrements orentereachchannelnumber
directly using the numeric buttons on the remote control.
Teletext
Your display can receive and display TOP/FLOF Teletext information.
. Select a television channel with Teletext.
. Pressthe [TEXT]button ontheremotecontroltodisplayTeletextoruse thenumericbuttonsto directlyselectTeletextpages.
The red, green, yellow and blue buttons on the remote control have different functions depending on the type of Teletext. They
are displayed at the bottom of the Teletext screen.
PC Mode
. Switch off the display and the PC.
. Connectyour PCand thedisplayusing the enclosedv ideo cable(DVIplug onthedisplayand HD-subconnectoronthePC).
. Switch ON the display and PC again.
PC (RGB) must be set in under the option <INPUTS /
PIP SOURCE>. When switched on, the display
automaticallydetectsthe pictureformatset on thePC.
This information is displayed in an info window - see
the drawing at the left side.
Operation with additional devices
Video recorder
. Switch OFF the display and video recorder.
There are 3 options for connecting your video recorder to the display:
D via the aerial lead; read the operating instructions for your video recorder on this subject
D using a SCART cable connected either to SCART1 or SCART2
D if your video recorder has an S-video output, connect this to the Y/C input.
. Switch the display and video recorder back ON.
. o switch over to the connected input (e.g. SCART1) press the [VIDEO] button repeatedly.
DVD player
Operation with Revox M51 and DVS module: see the operating manual DVS module
. Switch OFF the display and DVD player.
. Connect your DVD player via SCART1, YC input or YUV input, if it has an S-video output.
. Switch the display and DVD player back ON.
. To switch over to the connected input, press the [VIDEO] button repeatedly.
ENGLISH
TV -- 2 -- ZDF
STEREO
PC (RGB)
1024 x 768