Filter
Top Products
General operation
22 ENGLISH
Automatic switch-off
You canset thedisplayso thatitswitchesoffautomati-
cally after a certain amount of time.
. Under the option <SLEEP TIMER> select one of
the preset times 30 , 60 or 90 minutes.
When this period of time has elapsed the display swit-
ches off automatically.
Switching over to dual sound
Dual channelsound is intended for films where the viewer has the option to switch between thedubbed versionand the original
language.
If channels are transmitted with dual channel sound, channel ”A” is active first of all.
. Press the button [M/S] to switch over to channel ”B”.
Decoder mode
Under the option <INPUTS / PIP ⇒ MAIN INPUT SETTINGS ⇒ MANUAL SEARCH ⇒ OPTION> you can select the decoder
mode for each channel location.
Support of the HDTV standard
(High Definition Television)
Theinputports”PC(DVI)andPC(RGB)”areavailableforcomponents(receiver;set-topboxes)thatsupply outputsignalsincom -
pliance with HDTV standard.
The HDTV formats can be displayed: 480 i, 480 p, 576 p, 720 p and 1080 i.
The input port ”YUV” is not envisaged for HDTV. Picture distortions can occur, if the input signal is incompatible.
Progressive scan
(Input signal at the YUV input port)
Modern components (DVD players; set-top boxes)
have the facility to generate so -called ”progressive
scan signals”.These signalscan beprocessed viathe
YUV input port. You can activate the support via the
menu option <INPUTS / PIP ⇒ SETTINGS ⇒ YUV
PROGRESS.> ON.
The component must support the standard EIA-770.2.
Standard TV resolution (480 or 576 lines; for HDTV resolutions see HDTV)
HDCP compatibility
(High Bandwidth Content Protection)
Copying protection for the digital video interface DVI
(HDCP) is active when the input port ”PC(DVI)” is se-
lected and menu option <DVI-MODE> is set to
”HDCP”. If components without HDCP support are
connectedtotheinputport”PC(DVI)”,youmustsetthe
menu option <DVI-MODE> to ”PC”.
Ifyou areusing acomponent (DVDplayer)thatis notexactlyc ompliantwiththeHDCPstandard,picture errorsmay
occur. If any errors occur, switch the connected component OFF and back ON again.
Display Source Info: On
Language: Deutsch
OSD Set Up: >
Pwr Down/Stand--By: >
Resetto factory Defaults >
Sleep Timer: Off
←
Main inputsettings >
Main input: TUNER
YUV progress.: Off
←PIPMode: Off
←
Inputs / PIP >
Picture >
Display >
Sound >
Set Up >
Info >
HFreq: 60.0kHz
V Freq : 75.0 Hz
Pixel Clk : 78.75 MHz
H/V Pol : + / --
Overscan: Off
DVI-Mode: HDCP
←
Main inputsettings >
Main input: PC (DVI)
PIP Mode: Off
←
Inputs / PIP >
Picture >
Display >
Sound >
Set Up >
Info >