Filter
Top Products
18
Selecting an Aspect
Ratio
Basic Operations
1. Press the MENU button on the remote control.
2. Press the ▲▼ buttons to select Aspect Ratio and then press the ENTER or ►
button.
3. Select the appropriate Aspect Ratio by pressing the ▲▼ buttons and then press
the ENTER or ► button.
• You can select Anamorphic, Standard, Letterbox
or VirtualWide.
4. Press the MENU button to return to the previous menu.
OR
You can also select the Aspect Ratio directly from the remote control using discrete
Aspect Ratio buttons.
0
100
RGB
HD
TV
DVI
SLEEP
MEMORY
DISPLAY
TIMER
OFF
INPUT
1
INPUT
2
INPUT
3
INPUT
4
CUST
ISF
NT
IS
F
DAY
ANA 4X3
ASPECT RATIO
LET
BOX
VWIDE
CHANNEL UP
SOURCE
ANAMORPHIC mode
The Anamorphic aspect ratio expands the image in the
horizontal direction. The image is compressed vertically,
but with anamorphic software the image will appear
properly proportioned. This is best suited for use with
16:9 DVD’s and HDTV.
STANDARD 4:3 mode
The image is displayed at a standard 4:3 aspect ratio.
The input signal will be scaled to fit in the center of the
16:9 screen.
LETTERBOX mode
The image in the Letterbox mode will be zoomed in, and
the top and bottom portion ‘blanked off.’ This ratio is best
suited for LaserDisc movies or non-anamorphic DVD’s.
VIRTUALWIDE mode
The VirtualWide mode is an aspect ratio is designed to
fill the 16:9 screen with a 4:3 image. The center of the
picture is not stretched, and it gradually stretches on the
sides reaching the most extreme stretch at the far edges
of the picture (non-linear scaling). In addition, we apply
a very slight vertical stretch uniformly (no graduation)
which results in a very small amount of cropping of the
top and bottom of the image area. Thus a 4:3 image is
transformed into a 16:9 image with minimal distortion.
Active Image Area
Active
Image
Area
Active Image Area
Active
Image
Area
Runco CR-32HD
Source
Aspect Ratio
Picture Adjust
Audio
Channel
Ti
mer
Setup
ISF Calibration
> Anamorphic
Standard
Letterbox
VirtualWide