Filter
Top Products
Installation
16 Runco CX-40HD/CX-46HD Owner’s Operating Manual
PRE
L
IMINAR
Y
3.4
Connections to the
Crystal Series LCD
Display
Proceed as follows to connect the Crystal Series LCD Display to your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
• Use the left audio input when connecting mono audio sources.
Rear Connector Access To access the left rear connector panel, push down on the plastic clip holding the cover in
place. Then, pull firmly on the cable access cover to open it.
Connecting the Crystal
Series LCD Display to
Source
Components
Connect your video sources to the Crystal Series LCD Display as shown and described in
the sections that follow.
Antenna/Cable TV Connection: Connect your antenna or cable television source to the
AIR or CABLE jacks on the rear of the Crystal Series LCD Display; see
Figure 3-1.
Figure 3-1. Antenna/Cable TV Connection
➤
➤
Cable Television
Network
Input Panel