Filter
Top Products
Runco CX-40HD/CX-46HD Owner’s Operating Manual 25
PRE
L
IMINAR
Y
4.1
Turning on the Power
1. Turn on your source components.
2. Plug the female end of the supplied power cord into the AC receptacle on the rear of
the Crystal Series LCD Display (AC 100V ~ 240V). See
Figure 2-2.
3. Connect the other end to your AC power source.
4. Turn on the main power switch at the rear of the display. The power indicator lights
red to indicate that the Crystal Series LCD Display is in “standby” mode.
5. Press the ON button on the remote control to
turn on the display (or press the power button
on the side of the display). The power indicator
flashes for a few seconds, then lights solid
green.
6. After a brief warm-up period (approximately 10
seconds), the Crystal Series LCD Display will
display an image.
4.2
Changing the OSD
Language
The Crystal Series LCD Display OSD language is initially set to English, but can also
display the menus in French, Spanish, Portuguese or German. To change the OSD
language:
1. Press MENU.
2. Select Setup from the Main Menu.
3. Select OSD Language from the Setup Menu.
4. Press or to highlight the desired language and press ENTER. The change takes
effect immediately.
4. Operation
45
123
6
789
OFF ON