Filter
Top Products
Runco VX-33i Installation/Operation Manual 21
PRE
L
IMINAR
Y
3. Remove the Lens Cavity Front Cover.
4. Remove the Rear Lens Cap.
5. Hold the lens assembly with the motor
facing the upper-right corner of the
Lens Cavity. Carefully insert the back
of the lens assembly into the hole in the
lens flange.
DO NOT PUSH THE LENS ASSEMBLY
ALL THE WAY IN. Only push the lens
assembly in far enough so that the front
of the lens motor is clearly behind the
projector chassis cover.
6. Carefully rotate the lens assembly 45
degrees clockwise until the motor
socket connector is aligned with the
connector on the flange. Then, gently
push the lens assembly in until it is
seated flush against the flange and the
connectors have seated.