Filter
Top Products
60 Runco VX-33i Installation/Operation Manual
PRE
L
IMINAR
Y
6. Install the new lamp module.
7. Replace the lamp cover and re-tighten all
screws.
5.2
Filter Replacement
Whenever you replace the lamp – or more often if the projector is installed in an extremely
dusty environment – you should also replace the filter located at the right side of the
projector.
1. Loosen the four captive screws
holding the filter access panel in
place. Then, remove the panel.
2. Pull the filter out of the projector
and discard. Do not reuse filters.
3. Insert the new filter with the pleats
facing in and the foam-covered
side facing out.
4. Replace the filter access panel and
tighten the screws to secure it.
Side Filter
Access Panel