Filter
Top Products
Additional Information
English - 80
Sound
No sound.
Are you watching a program in scan
mode?
If you are playing a program at a speed
other than normal and fast1 speed, the
sound will not be heard.
Check the connections and settings.
Check whether the disc is damaged.
Clean the disc, if necessary.
Check whether the disc is inserted
correctly with the label facing up.
No audio output.
Check whether you have selected
the correct digital output options in
the Audio Output Options menu.
(See page 38)
Timer Recording
Timer lamp fl ickers.
Check if there is enough space in the
disc for recording.
Check whether the current disc is
recordable or not.
Make sure to check before the start
time of recording.
Timer recording does not work properly.
Re-check the recording time and the
end time settings again.
Recording will be cancelled, if the
power is disconnected due to a
power failure or other similar reason,
while recording.
HDMI
No HDMI output.
Check to see that the Video output is HDMI
enabled.
Check the connection between the TV and
the HDMI jack of the DVD Recorder.
See if your TV supports 480p/720p/1080i
resolution.
▌
▌
▌
Abnormal HDMI output screen.
If snow noise appears on the screen,
it means that the TV does not support
HDCP (High-bandwidth Digital Content
Protection).
If connected via DVI, try turning the DVD
Recorder off then On.
HDMI output Jitter
Check your TV system setup correctly.
Screen Jitter may occur when the frame
rate is converted from 50Hz to 60Hz
for 720p/1080i HDMI (High Defi nition
Multimedia Interface) Output.
Please refer to the user's manual of your TV.
Remote Control Unit
The remote control doesn't work.
Point the remote control at the remote
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder and
the remote control.
Check whether the batteries are empty.
Other
I forgot my password for parental supervision.
Remove the disc. Press the CH (
/ )
buttons on the front panel of the DVD
Recorder simultaneously for 5 seconds or
more when the power is on.
All settings including the password will
revert to the factory settings. Do not use
this unless absolutely necessary.
(Note that this function is possible only
when no disc is inserted.)
Is it possible to change a subtitle and an audio
signal on a recorded disc?
A recorded disc is played with only
the subtitle and the audio signal
which were selected during recording.
Other problems.
Read the table of contents and then fi nd
and read the section describing your
problem, and follow the instructions given.
Turn your DVD recorder off and on.
If the problem still persists, contact a
nearby Samsung service center.
▌
▌
Checkpoint 1
Checkpoint 2
Checkpoint 3
Checkpoint 4
Checkpoint 1
Checkpoint 1
Checkpoint 2
Checkpoint 1
Checkpoint 2
Checkpoint 3
Checkpoint 1
Checkpoint 2
Checkpoint 3
Checkpoint 1
Checkpoint 1
Checkpoint 2
Checkpoint 1
Checkpoint 1
Checkpoint 2
Checkpoint 3
Checkpoint 1
Checkpoint 2
Checkpoint 1
01378A-AR650-XAA-ENG.indb 8001378A-AR650-XAA-ENG.indb 80 2007-03-13 오전 11:57:092007-03-13 오전 11:57:09