Filter
Top Products
English -
21
There are several ways to output audio signal not using
scart cables. Select the audio connection that best suits
you below.
●
Case 1 : Connecting to your TV
●
Case 2 : Connecting to a stereo amplifier with AV
output jacks
●
Case 3 : Connecting to an AV amplifier with a
digital output jack
Case 1 : Connecting to your TV
If your TV has audio input jacks, use this connection.
Other type of connecting
the Audio output cable
Manufactured under licence from Dolby
Laboratories. “Dolby” and the double-D symbol
are trademarks of Dolby Laboratories.
“DTS” and “DTS Digital Out” are trademarks of
DTS, Inc.
yellow
white
red
yellow
white
red
Connecting & Setting Up
Case 3 : Component Video
output jacks
1. Connect Component video cables(not supplied)
between the COMPONENT OUT(Y,P
B
,P
R
) jacks on
DVD Recorder and COMPONENT IN(Y,P
B
,P
R
) jacks
on your TV.
2. Connect audio cables (white and red) between the
AUDIO OUT jacks on the DVD Recorder and AUDIO
IN jacks on TV (or AV amplifier).
(See pages 21-22).
3. After connecting, refer to the page 34 to 35.
●
You will enjoy high quality and accurate colour
reproduction images.
■
Make sure that the colour coded
connections match. The Y, P
B
, P
R
component output jacks of your DVD
Recorder must be connected to the exact
corresponding component input jacks on
your TV.
■
Progressive setting is only available when
the Video Out is set to Component.
(See page 34)
NOTE
green
blue
red
green
blue
red
01003E-R128,130-EUR_18~40 2/23/06 8:27 PM Page 21