Filter
Top Products
English-7
Switching On and Off
Your set can be placed in standby mode in order to reduce the power consumption. The standby mode can be useful when
you wish to interrupt viewing temporarily (during a meal, for example).
1. Press the POWER button on the remote control.
The screen is turned off and a red standby indicator appears on the front of your set.
2.
To switch your set back on, simply press the POWER , numeric buttons (0~9), TV/DTV button or channel up/down ( / ) button again.
Do not leave your set in standby mode for long periods of time (when you are away on holiday, for example).
It is best to unplug the set from the mains and aerial.
Placing Your Television in Standby Mode
When the TV is initially powered on, several basic settings proceed automatically
and subsequently. The following settings are available.
1. Press the POWER button on the remote control.
The message "Démarrer Plug & Play" is displayed with "OK" selected.
2. Select the appropriate language by pressing the 5 or 6 button.
Press the ENTER button to confirm your choice.
3. The message "Check antenna input." is displayed with "OK" selected.
Press the ENTER button.
Please check that the antenna cable is connected correctly.
4. Select the appropriate country by pressing the 5 or 6 button.
Press the ENTER button to confirm your choice.
5.
The "Auto Store" menu is displayed with the "Start" selected. Press the ENTER button.
The channel search will start and end automatically.
After all the available channels are stored, the "Clock Set" menu appears.
Press the ENTER button at any time to interrupt the memorization process.
6. Press the ENTER button.
Select the "Hour" or "Minute" by pressing the
3 or 4
button.
Set the "Hour" or "Minute" by pressing the
5 or 6
button.
You can also set the hour and minute by pressing the number buttons on the remote control.
7. Press the ENTER button to confirm your setting.
The DTV channel scan menu appears and the DTV channel is automatically updated.
If the DTV channel is updated, the Source in the source list of the Input menu is
automatically changed to DTV.
For detailed descriptions about DTV channel update, refer to page 27 of this manual.
Plug & Play
The mains lead is attached to the rear of your set.
1. Plug the mains lead into an appropriate socket.
The standby indicator lights up on the front of the set.
2. Press the button on the front of the set.
You also can press the POWER button or the
TV/DTV
button on the remote control to turn the TV on.
The programme that you were watching last is reselected automatically.
3.
Press the numeric button (0~9) or channel up/down ( / ) button on the remote control or button on the right side of the set.
When you switch the set on for the very first time, you will be asked to choose language in which the menus are to be displayed.
4. To switch your set off, press the POWER button again.
Language: Select your language.
Country: Select your country.
Auto Store: Automatically scans for and stores channels available in the local area.
Clock Set: Sets the current time for the TV clock.
If you want to reset this feature...
1. Press the MENU button to display the menu.
Press the 5 or 6
button
to select "Setup", then press the
ENTER
button.
2. Press the ENTER button again, to select "Plug & Play".
3. The message to
"Start Plug & Play"
is displayed.
BN68-01007C-00Eng.indd 7 2006-03-03 ¿ÀÈÄ 3:03:04