Filter
Top Products
21
INSTALLATION
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a
cable TV system (according to the instructions on pages 17 - 20). Skip step 1 if you have
not yet connected to an antenna or a cable system.
1
Unplug the cable or antenna from the back
of the TV.
2
Connect the cable or antenna to the
ANTENNA IN terminal on the back of the
VCR.
3
Connect a coaxial cable between the
ANTENNA OUT terminal on the VCR and the
antenna terminal on the TV.
4
Connect a set of audio cables between the
AUDIO OUT jacks on the VCR and the
AUDIO jacks (AV1~AV3) on the TV.
If you have a “mono” (non-stereo) VCR, use
the Y-connector (not supplied) to hook up to
the left and right audio input jacks of the TV.
If your VCR is stereo, you must connect two
cables.
5
Connect a video cable between the VIDEO
OUT jack on the VCR and the VIDEO jack
(AV1~AV3) on the TV.
Follow the instructions in “Viewing an
External Signal Source” to view your VCR
tape.