Filter
Top Products
33
OPERATION
Storing Channels in Memory
▼
Press the ENTER button at any time
to interrupt the memorization process
and return to the Channel menu.
▼
Note: The TV must be connected
to an antenna in order to receive digital
TV signals.
Even if a particular channel is deleted
from the memory, you can always tune
to that channel directly by using the
number buttons on the remote control.
▼
To return to the previous step,
move to “Return” by pressing the
button and then press the ENTER
button.
▼
Note: When Receiving Digital
Cable Signal :
If your cable service signal does not
comply with the ATSC(Advanced
Television System Communittee)
requirements, this product may not
operate properly.
6
Press the ENTER button
when channel memoriza-
tion is completed.
5
Press the … or † button
to select the antenna to
memorize, then press the
ENTER button.
The TV will begin memo-
rizing all of the available
channels.
Notes
• STD, HRC and IRC identify various types of cable TV systems. Contact your local cable
company to identify the type of cable system that exists in your particular area. At this
point the signal source has been selected. Proceed to “Storing Channels in Memory”.
• Subscription cable services require service-specific requirement for viewing.
4
Press the … or † button to
select antenna connection,
then press the ENTER
button.
Select the antenna connection
ANT A ANT B
When selecting Cable TV system:
Press the … or † button
to select “Cable”, then
press the ENTER button.
Press the … or † button
to cycle through these
choices: “STD”, “HRC” or
“IRC”, then press the
ENTER button.
Air None
Cable None
Air Cable
Cable Air
ANT A : Air
ANT A : Cable
ANT A : Air, ANT B : Cable
ANT A : Cable, ANT B : Air
T V Memorize Channels
Channel Memory in Process
CATV Channel 15
Stop Return
Memorize channels
Air None
Cable None
Air Cable
Cable Air
Select the cable system
STD
HRC
IRC
T V Memorize Channels
Select the antennas to memorize
ANT A + ANT B
ANT A
ANT B
T V Memorize Channels
Start
Start
Start