Filter
Top Products
05 MENU SETUP
menu setup _23
Search
The “Playback” item allows granting the search right.
Profile
Load Factory Default
This function is used when you reset all menu setting
values to the factory default values.
If you press “OK”, the restart message window
appears. You can select “Yes”. The recorded data will
not be deleted.
Profile Export
Allows you to configure multiple DVR units with ease.
This function is used when you export the profile
currently set to the system to the storage device
connected to a USB port. The profile file will be copied
to the USB memory if you press “OK”. (Filename:
SetupData.tar)
Profile Import
This function is used when you import the system
profile file stored in a USB memory and apply to the
current system. The profile file will be copied to the
current system if you press “OK”. Then, the restart
message window appears. You can select “Yes”.
Progress
This function will show the progress status of the job
that the system is currently executing.
Caution
Please do not remove the USB memory
when you run the profile export/import
function. The system profile file may
not be copied properly or may not be
applied to the system.
When the system profile file that is included
the value for network setup applies for
another DVR, an IP address conflict may
occur due to the same address. If so,
please reset the network configuration
to avoid an IP address conflict.
System Log
This function shows a series of logged tasks made in
operating the DVR system and when the system runs
abnormally, it allows finding the error easily so that the
problem can be fixed.
Press the Enter( ) button after moving the cursor on
the desired log item.
( ): Move to the previous page.
( ): Move to the next page.
Scope Designation
If the ( ) icon is pressed, the following screen
appears.
For the log data, set the “Start Time” and “End Time
” to be searched. To change the date and time, move
the cursor to the corresponding item and press the
Enter
( ) button. Then, change the day/month/year
or second/minute/hour using the
or
buttons.
Escape from the change mode by pressing the Enter
( ) button again.
Move/Control Select Exit
OK
OK
OK
OK
Profile
Load Factory Default
Profile Export
Profile Import
Progress
trying.. 0%
System Log
04-02 06:08:09 C3 C REC Stop
04-02 06:08:09 C3 M REC Start C3
04-02 06:08:47 C2 M REC Stop
04-02 06:08:47 C1 M REC Stop
04-02 06:08:50 C4 M REC Stop
04-02 06:08:50 C3 M REC Stop
2007-04-02 05:39:53
2007-04-03 05:39:53
REC
System
Failure
Search
Network
Backup
OK
OK
Start Time
2007 - 04 - 02 05 : 39 : 53
Year Month Day
2007 4 2
Hour Min Sec
5 39 53
Year Month Day
2007 4 3
Hour Min Sec
16 35 44
2007 - 04 - 03 16 : 35 : 44
End Time
SHR-6042_Eng.indb 23 2009-06-05 오전 11:23:38