Filter
Top Products
When Aerial Source is set to Terrestrial or Cable
• Digital Channel Tuning
Scans for a digital channel.
1.
Select the New.
✎
When selecting Aerial → Terrestrial: Channel, Frequency, Bandwidth
✎
When selecting Aerial → Cable: Frequency, Modulation, Symbol Rate
2.
Select the Search. When scanning has finished, a channel is updated in the channel list.
• Analogue Channel Tuning
Scans for an analogue channel.
1.
Select the New.
2.
Set the Programme, Colour System, Sound System, Channel and Search.
3.
Select the Store. When scanning has finished, a channel is updated in the channel list.
Channel mode
• P (programme mode)
When tuning is complete, the broadcasting stations in your area have been assigned to position numbers from P0 to
P99. You can select a channel by entering the position number in this mode.
• C (aerial channel mode) / S (cable channel mode)
These two modes allow you to select a channel by entering the assigned number for each aerial broadcasting
station or cable channel.
Fine-Tuning the Screen
Broadcasting → Channel Settings → Fine Tune
✎
Available for analogue broadcasts only.
Analogue pictures can become shaky and full of noise. If this happens, you can fine-tune the signal and/or reduce noise
to clear up the picture.
1.
Select Channel Settings → Fine Tune. An adjustment bar appears on the screen.
2.
Press the ¡ or £ button to make adjustments. Select Save or Close to apply the new setting. Select Reset to
reset the Fine-Tune operation.
English - 94 English - 95
Preference Features