Filter
Top Products
LIVE settings
33
2 Select the setting position (4 positions) using the control
button (}~).
3 Select the input terminal number (1 - 16) using the control
button ({|).
☞ In DSR-2108, input terminal number (1 - 8).
4 Press the ENTER button.
● Setting the VIDEO LOSS ON
An alarm signal is output when the specified video input
terminal receives a VIDEO LOSS occurs.
1 Select "VIDEO LOSS ON" using the control button ({|).
2 Select the setting position (4 positions) using the control
button (}~).
3 Select the input terminal number (1 - 16) using the control
button (}~).
☞ In DSR-2108, input terminal number (1 - 8).
4 Press the ENTER button.
● Setting the HDD ERROR
An alarm signal is output when a hard disk error occurs.
1 Select "HDD ERROR" using the control button ({|).
2 Select output ON or OFF using the control button (}~).
● Setting the ALARM DURATION
Sets the duration of the alarm output signal.
1 Select "ALARM DURATION" using the control button
({|).
2 Select the output duration (3 - 255 seconds) using the
control button (}~).
4
Select "ALARM IN NO." using the control button
({|) and specify the alarm input terminal number
(1-16) using the control button (}~).
Setting the signal polarity of the specified alarm
input terminal.
☞ In DSR-2108, input terminal number (1 - 8).
● Setting the TYPE
1 Select "TYPE" using the control button ({|).
2 Set the signal polarity using the control button (}~).
---: Does not react
N/OPEN (Normal Open):
Normally open, reacts when closed
N/CLOSE (Normal Close):
Normally closed, reacts when opened
Sets the output conditions of the monitor video terminal
(MON2).
1
Select "MON2-OUT" using the control button ({|)
and press the ENTER button.
The MON2-OUT screen is displayed.
2
Setting the output conditions of the MON2 terminal
● Setting the MON2 TYPE
Sets the output screen layout of the MON2 terminal.
1 Select "MON2 TYPE" using the control button ({|).
2 Select the screen layout using the control button (}~).
FULL: Single-screen output
QUAD: Quad-screen output
● Setting the MON2 ON EVENT
Sets whether the video of an event is output to the MON2
terminal while it is being recorded.
1 Select "MON2 ON EVENT" using the control button ({|).
2 Select ON or OFF using the control button (}~).
ON: The video of the event is output.
OFF: The video of the event is not output.
● Setting the MON2 EVENT DWELL TIME
If "MON2 ON EVENT" is set to ON, set the output duration of
the video of the event.
1 Select "MON2 EVENT DWELL TIME" using the control
button ({|).
2 Set the output duration (1 - 10 seconds) using the control
button (}~).
E F
Setting the MON2 (Monitor2)-OUT
MON2-OUT
MON2 TYPE FULL
MON2 ON EVENT ON
MON2 EVENT DWELL TIME 10 SEC
SEQUENCE OFF
SEQUENCE-DWELL TIME 10 SEC
MON2 CHANNEL 1
L8HBT_WA(DSR-2116_2108)(GB).book 33 ページ ２００９年５月２７日 水曜日 午後４時５０分