Filter
Top Products
27
TROUBLESHOOTING
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace batteries with four (4) new AAA
alkaline batteries.
PROBLEM: LED blinks when you press a key, but device
does not respond.
SOLUTION: Make sure the remote is aimed at your device
and is not more than 15 feet away.
PROBLEM: LED blinks one long blink.
SOLUTION: An entry error has occurred (for example,
wrong key). Try entry sequence again.
PROBLEM: Remote does not control devices or
commands are not working properly.
SOLUTION: Try all listed codes for the device. Make sure
the device operates with an infrared remote control.
PROBLEM: No volume on a second TV.
SOLUTION: See Changing Volume Lock.
PROBLEM: Channels do not change properly.
SOLUTION: If the original remote control required you to
press Enter to change channels, press Enter on this
remote after entering the channel number.
Call 1-866-950-6540 for further assistance.
SPECIFICATIONS
Power(4) AAA Batteries
Size (H x W x D) 9.7 x 2.7 x 1.4 in.
(245 x 68 x 35 mm)
Weight (w/o batteries)6.6 oz. (205 g)
Specifications are typical; individual units might vary.
Specifications are subject to change and improvement
without any notice.
RF EMISSIONS INFORMATION
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
RadioShack 8-in-1 LCD ENG.fm Page 27 Friday, February 9, 2007 6:11 PM