Filter
Top Products
If your TV has A/V input jacks, you may connect your
VCR's AUDIO/VIDEO OUTPUT jacks to the
audio/video input jacks on back of your TV.
Direct audio/video connections usually result in a better
picture and sound quality for tape playback. Please see
your TV's owner's manual for details.
Then, set your TV to the Video mode using TV/VCR
button on your "IV.
[Back of the unit}
_lr oAUDIO0
l- ov,0 oe
ideo "Y_'_
,.v.+,,,00,
++, II°o
9oo,9
TO COPY A VIDEO TAPE
Connect the editing (recording) VCR, the source (playing) VCR and your TV using the following diagram.
NOTE: You can use the audioand video inputjacks on the front panel atediting(recording) VCR instead of using
acks on the back.
Main Unit
[Editing(Recording)VCR]
* Coaxial cable (supplied)
AudioNideoadapter
(not supplied)
[Source (Playing) VCR] r_ _ _ oEo?_o_O
31
+o
,0 Antenna input jack
cord
U_sset]
e for monitoring)
1. Insert a pre-recorded video cassette into the
source(playing) VCR.
2. Insert a blank video cassette, or one you want to re-
cord over, into the editing(recording) VCR cassette
compartment.
3. Press SPEED button on the editing(recording) VCR
to select the desired recording speed (SLP, LP or
SP).
4. Select L I or L2 position on the editing(recording)
VCR. See page 13, under"Input Select".
5. Press REC button on theediting(recording) VCR.
6. Begin playback of the tape in the source(playing)
VCR.
NOTE: For best results during dubbing, use the VCR's
front panel controls whenever possible. The remote
control might affect the playback VCR's operation.
• Always use video-quality shielded cables with
RCA-type connectors. Standard audio cables are not
recommended.
• You can use a video disc player, satellite receiver,
or other audio/video component with A/V outputs in
place of the source(playing) VCR.
TO MONITOR THE RECORDING
!. Turn on the TV and set itto the same output channel
as the editing(recording) VCR channel 3 or 4.
2. Press TV/VCR button on the editing(recording)
VCR so that "VCR" appears on the display.
-12- EN
_*,_-k _r 5C16