Filter
Top Products
If your cable service supplies you with acable converter box, you can use the basic connection shown below.
TO RECORD AND VIEW A SCRAMBLED/UNSCRAMBLED CHANNEL.
I. Press TV/VCR button so that "VCR" appears on the
display.
2. Set the TV channel to the same video output channel
as the switch located on the back of the VCR (CH3
or 4).
3. Set the VCR channel selector to the output channel
of the Cable Converter box. (EXAMPLE CH3)
4. Select the channel to be recorded at the Cable Con-
verter Box.
NOTES:
• With this connection, you CANNOT record one
program while viewing another.
• Channel memory programming is NOT needed when
using this connection.
CableTV ToVCR'sANT,IN Terminal
ConvenerBox I
:::i-i'.illl
/ / _ Jack
CATV(Cable) ToVCR'sANT.OUTTerminal
Input
CONTROLLING VCR INPUT & OUTPUT
When the VCR isin the Playback mtxie, or when the TV/VCR button is in the VCR position,
your TV will receive the signals from the VCR on either channel 3 or 4. Set the 3CH/4CH
selector switchto the stationthat is not used fornormal broadcasts inyour area; then set your CH3 CH4
TV to that same channel when viewing from theVCR.
The video output channel of this unit is set to channel 3 prior to shipment from the factory.
To use the external input jacks, select the "LI" or "L2" position.
• If you use the audio and video input jacks on the back of the unit, press 0, 0, I with number buttons to select
the "LI" position.
• If you use the audio and video input jacks on the front of the unit, press 0, 0, 2 with number buttons to select
the '%2" position.
You can select "LI", '%2" as a channel by using the CHANNEL "A" or "V" button.
Note: "I.,1"and "I.,2" are found before the lowest memorized channel. (Example: CH2)
[vdI I) _Ol_V_[0] |] N_ NmKN H[0]_1 [0]_1MIk"i
TV power must be on. Please see your TV's owner's manual/or details.
To Set TV to the Video Mode
your
Connection Using AV Cord Set your TV to the Video mode using TV/VCR buttonof your 'IV.
(Refer to page 12.) To set your TV to the TV mode, press TV/VCR button of your TV again.
Connection Without AVCord Set the TV channel to the same video output channel located on the back of theVCR.
(Refer to page 10, Ii, 13.) (CH 3 or4) Then, set your VCR to the VCR mode using TV/VCR button of your VCR.
- 13- EN
***** 5C16