Filter
Top Products
When the programs overlap, Quick Set Program
has priority. But if an another program has been acti-
vated when the start time of the Quick Set Program
comes, the Quick Set program will be begun after fin-
ished the faster program.
PROGRAM 2
I I
oui, s., P,oQ,,__pR0a,AM8_
I i
9:00PM 10:00PM 11:00PM
12:00AM
If you program as per the illustration the timer record-
ing would be carried out as follows.
9:00AM - 11:00AM for PROGRAM 1
11:00AM- 12:00PM for PROGRAM 8
(Quick Set Program)
12:00PM - for PROGRAM 2
TO CHECK THE START/END TIME
To check the start!end time and channel number, first
press POWER/TIMER REC button so that "[]" indi-
cator appears, then press QUICK SET PROGRAM
button once. Both the start and end time will appear for
3 seconds each, and return to the Timer Stand-by m_xle.
8
I_ WED
[]
S:D-I
!,
8
reT¢l WED
[] CH
START
9:30 61
I,
8
ra]_! WED
[] CH
TO CANCEL A QUICK SET
PROGRAM
• While setting a program; press STOP/EJECT but-
ton on the VCR.
• After setting a program; (power must be on)
First, press QUICK SET PROGRAM button.
Then, press STOP/EJECT button.
• While recording is in progress; press STOP
/EJECT button.
HINTS
• If there is a power failure or the VCR is unplugged
for more than 3 seconds, the clock setting and all
timer settings will be lost.
• If the tape runs out before the end time, the VCR will
switch to the Stop mode immediately, eject the tape
and the VCR power will be turned off. The "1_" in-
dicator will flash.
• If a tape is not inserted or the erase-protection tab is
removed, the "[]" indicator flashes and automatic
timer recording cannot occur. Insert a tape that al-
lows recording.
• The TV that is connected to your VCR may be
turned ON or OFF when the VCR is inthe timer-re-
cord mode.
- 23 - EN
,k-Cr,_ 4_-k 5C16