Sharp 10P06-MX-NM Flat Panel Television User Manual


 
18
Antenna/STB
Select the type of connection you will use to
watch TV.
3
Press
c
/
d
to select "Antenna" or "Set Top Box",
and then press ENTER.
To watch TV via an antenna or cable connection
(without using a set-top box), select "Antenna", and
then go to step 4.
To watch TV via a set-top box, select "Set Top Box".
The setup screen for the connected equipment is
displayed. See the operation manual of the connected
equipment for setting up the equipment.
Set Top Box
Antenna
Air/Cable (Antenna setting)
Make sure what kind of connection is made with your
TV when selecting "Air" or "Cable".
4
Press
c
/
d
to select "Air" or "Cable".
Press ENTER to enter the setting.
Cable
Air
CH Search (Channel search)
Channel auto search makes the TV look for all
channels viewable in the set area.
5
When "Air" is selected in Antenna setting:
Press
c
/
d
to select "Start", and then press
ENTER.
Cancel
Start
When "Cable" is selected in Antenna setting:
Press
a
/
b
to select "Analog & Digital Search
Start" to search both analog and digital broadcasts,
or to select “Analog Search Start” to search only
analog broadcasts, and then press ENTER.
Analog Search Start
Cancel
Analog & Digital Search Start
The Channel search will start automatically.
To exit the Channel search screen, select "Cancel",
and then press ENTER.
Finish
6
The settings confi rmation screen is displayed.
Confi rm the information displayed on the screen,
and then press ENTER.
Even if you selected "Set Top Box" in step 3 above, a
confi rmation screen is displayed after the necessary
settings are completed.
OK
If no channel is found, confi rm the type of connection
made with your TV and try "EZ Setup" again.
(See page 30.)
For changing the settings of the Initial Installation, perform
"EZ setup" on the Initial Setup menu on page 30.
Watching TV