Sharp 10P06-MX-NM Flat Panel Television User Manual


 
7
1
Confi rm that there are 9 screws (5 short screws
and 4 long screws) supplied with the stand unit.
2
Attach the supporting post for the stand unit onto
the base using the box for the stand unit as shown
below.
The supporting post attaches to the base at an off-
centered location on the base. Be sure to attach the
supporting post in the direction indicated below and
attach the stand to the TV with the wider side of the
base facing forward.
Long screws
3
Insert the stand into the openings on the rear of the
TV.
Soft cushion
4
Insert and tighten the 4 screws into the 4 holes on
the rear of the stand unit.
Short screws
5
1
Insert the stand cover.
2
Insert the screw to secure the stand cover.
1
2
Short screw
• To detach the stand, perform the steps in reverse
order.
Supplied Accessories
Make sure the following accessories are provided with the product.
Remote control unit
(
g
1)
Page 8
“AAA” size battery
(
g
2)
Page 9
Stand unit
(
g
1)
Page 7
Cable clamp
(
g
1)
Page 8
LC-52LE920UN
Operation manual (
g
1)
Connection guide (
g
1)
Wireless LAN adapter
(
g
1)
Page XX
• Always use the AC cord supplied with the TV.
• The illustrations above are for explanation purposes and may vary slightly from the actual accessories.
QUICK REFERENCE
Attaching the Stand
• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
Attach the stand in the correct direction.
Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.