Filter
Top Products
20
3
Press
a
/
b
to select the time zone where you are
using the TV, and then press ENTER.
Example
CST
MST
PST
AKST
HAST
EST
• The time zone differs depending on the selected
country.
• The factory preset value is the time zone for the capital
of the selected country.
4
Press
a
/
b
to select the Daylight Savings Time,
and then press ENTER.
Manual
Off
Auto
• “Auto” is the default selection.
TV Location
Select "Home" or "Store" for the location where you
plan to install the TV.
5
Press
c
/
d
to select "Home" or "Store".
Press ENTER to enter the setting.
Select
Store
Home
Home: "Power Saving" is set to "Advanced", and AV
MODE is set to "STANDARD".
Store: "Power Saving" is set to "Off" and AV MODE is
set to "DYNAMIC (Fixed)". Picture Reset and Feature
Demo can be set.
Picture Reset: AV MODE will be set to "DYNAMIC (Fixed)"
regardless of whether Picture Reset is "On" or "Off".
• If you select "On" and there is no operation for 30 minutes:
-
AV MODE will be reset to "DYNAMIC (Fixed)" and, when a
3D signal is detected, 3D images will switch to 2D images.
• When "Off" is selected:
- AV MODE will be set to "DYNAMIC (Fixed)".
Feature Demo: When "On" is selected, after all the settings
are completed, the Feature Demo screen is displayed if there
is no operation for several minutes.
Antenna & Cable/STB
Select the type of connection you will use to
watch TV.
6
Press
c
/
d
to select "Antenna & Cable" or "Set-
top box", and then press ENTER.
Set-top box
Antenna & Cable
To watch TV via an antenna or cable
connection (without using a set-top box):
Select "Antenna & Cable", and then go to step 7.
To watch TV via a set-top box:
1
Select "Set-top box", and then press ENTER.
2
To watch TV, select the input source
corresponding to the terminal connected to the
set-top box. When doing so, you must make
the setting to skip "TV". Press
c
/
d
to select
"On", and then press ENTER.
Off
On
• When this is set to "On", the channel on the TV
cannot be changed using the remote control unit or
menu. (e.g. CH
U
/
V
, Favorite CH, etc.)
• See page 34 for details on the Input Skip function.
3
Press INPUT to select the input source
corresponding to the terminal connected to the
set-top box. Make the necessary settings on
the connected external equipment.
• See the operation manual of the connected
equipment for setting up the equipment.
Air/Cable (Antenna setting)
Make sure what kind of connection is made with your
TV when selecting "Air" or "Cable".
7
Press
c
/
d
to select "Air" or "Cable".
Press ENTER to enter the setting.
Cable
Air
Watching TV