Filter
Top Products
45
Enjoying 3D Image Viewing
Attaching the Nose Pad
Attach either of the supplied nose pads as needed
(such as when the glasses do not fi t properly). The
glasses come with a large and small nose pad.
1
1
2
Attaching the nose pad Removing the nose pad
Using the 3D Glasses
Turning the Power On/Off
Slide the switch to 2D or 3D to turn on the power.
Slide the switch to OFF to turn off the power.
• When the battery power is low, the LED light blinks once
every second after the power is turned on.
Switching to 3D and 2D Mode
When viewing 3D images, you can slide the switch
between 2D and 3D modes. This is useful when
several people are viewing 3D images on the same TV
with some people wanting to watch in 3D and some
people wanting to watch in 2D.
■
Viewing 2D images
When you slide the switch to 2D while viewing 3D images,
the 3D images switch to 2D images.
■
Viewing 3D images
When you slide the switch to 3D while viewing 2D images,
the 2D images switch to 3D images.
Usage Range of the 3D Glasses
The 3D Glasses can be used by receiving an infrared
signal sent from the TV.
The 3D Glasses turn off automatically after 10 minutes
if no signal is received from the TV.
■
Operating range
From directly in front of the 3D infrared emitter on the TV:
approx.17 ft (5 m)
(within approx. 30° horizontally and 20° vertically)
Recharging the 3D Glasses
When the battery power is low, the LED light blinks
one time per second. If the 3D Glasses battery is low,
you can recharge the 3D Glasses by connecting the
supplied USB cable to the TV and the USB terminal on
the 3D Glasses.
1
Turn off the TV, and then slide the switch on the 3D
Glasses to OFF.
2
Connect the cable shown at step 3 of this
procedure and then turn on the TV. Make sure the
cable is connected before turning on the TV.
• The LED light blinks approximately every two seconds,
and then starts recharging.
• When the LED light goes off, the recharge is complete.
It takes approximately 90 minutes to complete the
recharge.
• Insert the USB cable again if the LED light blinks on and
off once every 0.5 seconds. If it still does not respond,
inquire with a retail dealer or Sharp Authorized Service
Center.
3
After the recharge has completed, turn off the
TV, and then remove the USB cable from the 3D
Glasses.
1
USB cable
(supplied accessory)
2
USB terminal
CAUTION
• Do not recharge while wearing the 3D Glasses.
• Be sure to turn on the TV when you recharge the 3D
Glasses. If the TV is turned off, the 3D Glasses may not
recharge.
• When you recharge the 3D Glasses, only connect the
supplied USB cable to a USB terminal on the TV.
• The battery will not recharge during usage with the USB
cable connected. The 3D Glasses battery will not be
recharged if the switch is set to 2D or 3D. To recharge the
battery, set the switch to OFF.
• Recharge the battery within the operating temperature
(50°F–104°F/10°C–40°C). The battery may not be able to
recharge outside of the operating temperature.