Filter
Top Products
10
www.sharp.co.uk/support
INSTALLING YOUR VCR
AUTO INSTALLATION OF A SATELLITE RECEIVER/
CABLE BOX CONTINUED
12.
Press[ / ]to select SAT NO.
•
Sky Digital Installation
If you wish to install the preset Sky Digital receiver channel list, enter the code
035
. While
the arrows on the screen are moving from VCR to SAT a test signal of channel 012 is being
sent out from the VCR. Please ensure your Sky Digi box responds to this signal (“
012
channel unavailable” will appear on the screen). A list of preset digital channels can be
found at the back of the operation manual.
•
Other Analogue Satellite Systems
Refer to the table at the end of this manual. Look for the make of your satellite receiver
and use the
NUMBER BUTTONS to enter the first code number listed. For example
number 8 should be entered 0 0 8. Your satellite should now change to preset channel 12.
NOTES:
13.
Once your Satellite Receiver has responded to the
VCR press the
SET button to continue.
The VCR will attempt to copy the TV preset list
(NexTView, Smart Link, Easy Link and Megalogic
compatible TV’s only). During the copying process
the display will show the TV presets that are being
copied. If the VCR is unable to copy the TV preset list
the terrestrial and satellite channels will be
automatically installed. (Auto install may take a few
minutes.)
See next page to continue
• If your satellite receiver has not changed to preset channel 12 enter the next code
number on the list. Continue until the receiver shows preset channel 12, then continue
from point 13.
• If your satellite receiver is not in the manufacturers list or after entering all the numbers
listed for your receiver, the receiver preset channel has still not changed to 12, enter
001
and check your receiver. If it has not changed press to select 002 and re-check. If it
has changed continue from point 13.
• If there is still no response, try adjusting the position of your satellite receiver.
If you connect a Satellite Receiver to the VCR for the first time, after auto-installation
or you are replacing your existing Satellite Receiver, you may need to perform a
complete Auto Installation Procedure to re-tune your VCR. (Refer to
SATELLITE
RECEIVER / CABLE BOX INSTALLATION.)
MENU SELECT
BUTTONS
SET
REMOTE
SET
TINS-A082UMN1.book Page 10 Monday, November 4, 2002 2:33 PM