Filter
Top Products
21
www.sharp.co.uk/support
BASIC OPERATION
HOW TO CHECK, CHANGE AND CANCEL A DELAYED
RECORDING
Before you start!
• If the Timer Standby symbol appears on the VCR display,
press the
TIMER ON/OFF button to remove the
symbol.
CHECKING A RECORDING
1. Press STOP to switch on the VCR.
2. Press the MENU button.
3. Press[ / ]to select TIMER. Press the
SET button to confirm.
• All the delayed recordings in the VCR’s memory
will be shown.
4. If the settings are correct press the MENU
button to exit.
• If you wish to change or cancel any settings,
follow the procedures below.
CHANGING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING above.
2. To change a delayed recording, press
[ / ] to highlight the recording, then press
the
SET button to select.
3. Press[/]to highlight the setting to be
changed and correct it by using the[ / ]
or the
NUMBER BUTTONS.
4. When all corrections are complete press the
SET button to confirm, then press the
MENU button to exit.
CANCELLING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING above.
2. To cancel a delayed recording, press
[ / ]to highlight the recording to be
cancelled, then press
CLEAR.
3. Press the MENU button to exit.
NOTE:
• If there are some programmes to be recorded, do not forget to press TIMER ON/OFF
button to return the VCR to Timer Standby mode.
MENU SCREEN
TIMER
MODE
SET UP
įĬ :SELECT
SET : ENTER MENU: EX I T
SET
1/2
DATE PR START STOP
21/060212:0013:00SP*
--/-- -- -:-- -:-- ---
--/-- -- -:-- -:-- ---
--/-- -- -:-- -:-- ---
SET
SET
1/2
DATE PR START STOP
21/060212:0013:00SP*
--/-- -- -:-- -:-- ---
--/-- -- -:-- -:-- ---
--/-- -- -:-- -:-- ---
TINS-A082UMN1.book Page 21 Monday, November 4, 2002 2:33 PM