35
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL CONTINUED
7. Press [ / ]to select CHANNEL.
8. Press [ / ] to start tuning in either
direction. Tuning will stop when a channel is
received. If it is not the desired channel, press
[
/ ] to continue tuning.
9. Press [ / ] to select FINE TUNING.
Press and hold [
/ ] until the sharpest
colour picture is obtained.
11. Press [ / ] to select SKIP then [ / ]
to select ON or OFF.
12. Press SET to store this channel. The VCR
will increment to the next channel up.
• If any more channels are to be tuned in,
repeat this procedure.
• Once all the channels have been tuned in.
Press
MENU to return to the normal
screen.
IMPORTANT NOTE:
10. Press [ / ] to select DECODER. This
is preset to OFF. If you connect a satellite
receiver into VCR L2, as shown previously,
leave decoder OFF. If you connect a
decoder, as shown previously, you must
use [
/ ] to turn the decoder function
ON. Refer to
DECODER SWITCHING
OPERATION.
The SKIP function determines whether the
channel can be selected when using the
VCR CHANNEL / buttons
instead of the
NUMBER BUTTONS.
MENU SELECT
BUTTONS
MENU
SET
REMOTE CONTROL
SET
231
VIDEO
Plus+
TINS-A082UMN1.book Page 35 Monday, November 4, 2002 2:33 PM
