Filter
Top Products
25
www.sharp.co.uk/support
ADVANCED OPERATION
PLAYBACK OF A VIDEO TAPE
CHECKING THE AMOUNT OF TAPE REMAINING
When you load a video tape into the VCR it can calculate approximately the amount of
video tape remaining in hours and minutes. This is useful in determining whether or not there is
sufficient tape left to make a recording.
When a video tape is playing, the amount of tape remaining is calculated for you
automatically.
To display the amount of video tape remaining:
1. Load the video tape into the VCR
2. Press DISPLAY on the remote control as many times as necessary until “R” appears on
the VCR display. The tape will wind forward for a few seconds and then return to its
original position. The tape remaining will be shown on the VCR display in hours and
minutes.
By pressing the
TAPE SPEED button on the remote control the remaining time will
change between standard play, long play and extended play.
For example,
in standard play 1 hour 23 minutes is left on the tape:
in long play 2 hours 46 minutes is left on the tape:
in extended play 4 hours 9 minutes is left on the tape:
NOTES:
PLAYING BACK A VIDEO TAPE REPEATEDLY
You can set your VCR to automatically rewind at the end of playing a video tape and replay
the entire tape again. REPEAT will appear on the on-screen display when selected.
To use this feature:
1. Press the MENU button to display the
main menu on the screen.
2. Press the[ / ]menu select buttons to
select MODE.
3. Press the SET button.
4. Press [ / ]to select REPEAT.
5. Press [/]to select ON or OFF.
6. Press the SET button to confirm and return
to the main menu screen.
7. Press the MENU button to exit to normal
screen.
• If tape remaining function is interrupted, the remaining time will not be displayed.
• If less than 5 minutes of tape remains the display will flash.
MODE MENU SCREEN
BLUE MUTE AUTO OFF
➝REPEAT ON OFF
16:9 ON OFF
įĬ :SELECT ǡǠ : CHANGE
SE T : ENT ER MENU : EX I T
SET
SET
TINS-A082UMN1.book Page 25 Monday, November 4, 2002 2:33 PM