Filter
Top Products
Chapter 7 – Macro Function
33
and sending the tape
play command.
Push the MACRO
button to scroll
through the 3 options:
A = 2 sec. B = 5 sec.
and C = 10 sec.
Select the 2-second
delay (fig. A.).
Note: You can set a
time delay between
any two commands.
A.
B.
C.
10
5
2
MACRO
MACRO
MACRO
Press play. This
command will start
playing the tape in
your VCR when the
macro is running.
Press LEARN to exit
the macro sequence.
You can create another macro at this time by selecting another macro-run
button and entering another sequence of commands.
…or press LEARN again to exit the macro function.
Running the macro
To run the macro, press the AUX device button. Press the 1 button. Be
sure to aim the SUR-20 at the devices while the macro sequence is
being sent.
The following macro will begin:
1. TV turns on
2. TV switches to video mode
3. VCR turns on
4. Two-second delay.
5.
VCR starts playing tape
To restore the AUX’s 1 button to its original function delete the macro
using the delete button function. Refer to Using the delete function in
Chpt. 6.
Quick start guide to setting up a Macro.