Filter
Top Products
35
Chapter 8
Chapter 8Chapter 8
Chapter 8
Overview:
The following section will tell you how to:
• Adjust the sensitivity of the backlight.
• Turn off the beep signal.
• Recall the original LCD layout.
Adjusting the LCD backlight
You can adjust the LCD backlight sensitivity and the length of
time that the backlight stays on after you press the LCD
panel. Important Note: the room light sensor appears as a
small dark spot located above the MACRO button at the top
of the unit and it may be visible when the backlight is on. This
is normal. Refer to these instructions
:
Press the AMP and
the AUX buttons at
the same time for
three seconds to
enter the LCD
backlight configuration
mode.
You will hear two
beeps and then see
the
password screen
to the right.
Note: This screen
prevents you from
accidentally modifying
your SUR-20.