Filter
Top Products
14
GB
Getting Started
5 Attach the post to the base.
Insert the post so that the slit on the lower part of the post aligns with the projection of the base,
then secure the post with the two screws.
Note
• Make sure that the slot on the post aligns with the projection of the base by rotating the post slightly.
6 Adjust the height of the speaker.
Loosen (but do not remove) the screws, adjust the height of the speaker, then secure the screws.
Adjust the speaker of one side, then adjust another speaker by checking lines as a guide.
Note
• When adjusting the height of the speaker, grasp the speaker so that the speaker does not fall.
Base
Post
,
Slit
Projection
Screws
(small)
Lines
Loosen two screws.
,
Post
Secure two screws.