Filter
Top Products
54
US
BDV-N9100W/BDV-N8100W/BDV-N7100W
4-456-334-12(1)
D:\NORM'S JOB\SONY HA\SO130019\BDV-N9100W (PMRF
01)\4456334121_US (U)\080OTH.fm
masterpage: Left
• In TV or STB mode, if you press any of the
buttons above, the TV or STB button lights up.
(However, depending on the code setting, some
buttons may not work, and the TV or STB
button may not light up.)
• Depending on the TV or equipment you may not
be able to use some of the buttons.
You can control non-Sony equipment by
changing the preset code of the remote
control.
1 Press HOME.
The home menu appears on the TV
screen.
2 Press B/b to select [Setup].
3 Press V/v to select [Remote
Control Setting Guide], then
press .
4 Press V/v to select [Preset
Mode], then press .
5 Press V/v to select the
equipment type that you want to
operate with the supplied remote
control, then press .
6 Press V/v to select the device’s
manufacturer, then press .
7 Press POP UP/MENU while
pressing TV (for a TV) or STB (for
a cable box, digital satellite
receiver, digital video recorder,
etc.).
8 When the TV or STB button
starts flashing, enter the code on
the TV screen using the number
buttons, then press ENTER.
If you successfully set the code, the TV
or STB button will flash twice slowly.
If the setting is unsuccessful, the TV or
STB button will flash five times
quickly.
• You can exit Preset mode by pressing the TV or
STB button (whichever button is flashing).
• If you do not operate the remote control for
more than 10 seconds during presetting mode,
the remote control exits from presetting mode.
1 While holding down AV ?/1, hold
down VOL –, then press CH –.
The BD, TV, and STB buttons light up.
2 Release all buttons.
The BD, TV, and STB buttons turn off
and the preset code is cleared. The
remote control returns to its default
settings.
m/M
zz
./>
za
N PLAY
zz
X PAUSE
zz
x STOP
zz
MUTING
zz
VOL +/–
zz
CH +/–
zz
SLEEP (INPUT)
zz
Note
Changing the preset
code of the remote
control (Preset mode)
Button Remote’s mode
TV STB
Note
Resetting the remote
control