Filter
Top Products
Overview
Setup Preparation
16
Setup Preparation
Before you start to use the unit after you have made the
required connections, it is necessary to perform the
following operations.
• Selecting either NTSC or PAL video signal system
Select the video signal system used in your region.
For detailed information, see “Selecting Either NTSC
or PAL Video Signal System” (page 16).
• Setting the date and time
You should set the date and time when you start the
unit for the first time.
For detailed information, see “Setting the Date and
Time” (page 18).
• Selecting the remote interface
Select the remote interface to be used to control the
unit remotely. At the factory, RS232C is selected as
the default. If you want to use either USB or i.LINK,
change the remote interface setting.
For detailed information, see “Selecting the Remote
Interface” (page 20).
Selecting Either NTSC or PAL Video
Signal System
When you use the unit for the first time, you should
select the video signal system. The TV SYSTEM sub
menu of the ENHANCED MENU of the SETUP MENU
allows you to select either the NTSC or PAL video
signal system.
For detailed information on menu operations, see
“Basic Menu Operations” (page 50).
Note
At the factory setting, the NTSC video signal is selected
as the default. Even if your monitor does not correspond
to the video signal system currently selected, you can
carry out the menu operations using the main display
section of the front panel display.
Select the proper video signal system corresponding to
the one used in your area.
1
Press the MENU button.
The TOP menu appears.
2
Select “SETUP MENU” by pressing the V or v
button.
“SETUP MENU” is highlighted.
3
Press the b button.
10
1
3,5,6,8
2,4,9
11,12
4,6,7