Chapter 12
Setup Menus
12-26
Chapter 12
Setup Menus
12-4 Items in the Extended Setup Menu
Menu items in the range 800 to 899, relating to audio control
Specify the time for cross-fade or fade in/out editing of audio signals.
5 ms, 10 ms , 15 ms, 20 ms, 25 ms
a)
, 50 ms
b)
, 85 ms, 115 ms
c)
Note
The cross-fade or fade in/out operation means that the recording is rewritten from
the OUT point for the length specified by this setting. Even at the minimum 5 ms
setting, a length of recording corresponding to a field is rewritten.
To avoid rewriting, set menu item 317 AUDIO EDIT MODE to “CUT”, but in this
case there is an audio discontinuity at the edit point. There is no effect on the
recorded video signal.
a) Cross-fade time is 24 ms.
b) Actual value is 49 ms.
c) Actual value is 114 ms.
Select the mode in which digital audio levels are displayed.
PEAK.0 : Displays the audio level as negative values with the maximum level set
to 0 dB.
REF.0: Displays the audio level as positive and negative values with the
reference level set to 0 dB.
Item number
Item name
Settings
802 DIGITAL AUDIO MUTE IN
SHUTTLE MODE
Set the digital audio muting conditions during shuttle playback.
OFF : Not muted.
CUEUP: Muted during cue-up or preroll operations.
FULL: Muted in shuttle mode.
805 AUDIO MONITOR
OUTPUT MIXING
Select the audio mixing method used for digital audio signals and Betacam
playback analog audio signals supplied to the MONITOR OUTPUT connector.
ADD: Simple addition
RMS : Root-mean-square
AVE: Simple average
806
LEVEL METER SCALE
803 DIGITAL AUDIO FADE
TIME
801
DIGITAL JOG SOUND
Turns the digital jog sound on and off
OFF: Digital jog sound is turned off.
Audio of digital channels not subjected to speed correction is output. When the
tape stops, after one second the audio is muted.
ON : Digital jog sound is turned on.
When the tape speed is in the range × –1 to × 1 (for Betacam SX playback, in the
range × –1 to × 2), speed correction is carried out, and the same jog sound as a
conventional analog VTR is output.