Filter
Top Products
Additional Information
81
GB
Sound
There is no picture when you
make a component video cable
connection.
• You have set progressive format but your TV cannot accept the signal in
progressive format. In this case, return the setting to interlace format (the
default setting) (pages 36, 71).
• You have set [PROGRESSIVE (COMPONENT OUT)] in [VIDEO SETUP] to
[ON] (page 71) even though your TV cannot accept the progressive signal. In
this case, disconnect the HDMI cable from the unit and then set to [OFF].
• Even if your TV is compatible with progressive format (525p/625p) signals, the
image may be affected when you set progressive format. In this case, return the
setting to interlace format (the default setting) (pages 36, 71).
Picture noise appears. • If the picture output from your system goes through your VCR to get to your
TV, the copy-protection signal applied to some DVD programs could affect
picture quality. Connect the unit directly to your TV.
An image is not displayed on the
entire TV screen.
• Check the setting of [TV TYPE] in [VIDEO SETUP] (page 71).
• The aspect ratio on the disc is fixed.
Color irregularity occurs on the
TV screen.
The system’s speakers contain magnet parts, so magnetic distortion may occur.
When color irregularity occurs on the TV screen, check the following items.
• Install the speakers at least 0.3 meters (1.0 ft) from your TV set.
• If the color irregularity persists, turn off your TV set once, then turn it on after
15 to 30 minutes.
• Make sure that no magnetic object (magnetic latch on a TV stand, health care
device, toy, etc.) is placed near the speakers.
• Reposition the speakers farther away from your TV set.
Playback picture becomes
distorted.
•Set [YC
BCR] in [YCBCR/RGB (HDMI)] to [RGB] (page 73).
Symptom Problems and solutions
There is no sound. • The speaker cord is not connected securely.
• Check the speaker settings (page 76).
There is no sound when the
component (digital satellite
receiver, PlayStation 3, etc.) is
connected directly to your TV
via HDMI.
• Check the following status.
– Connect an audio cable from the AUDIO OUT (audio out) jack of your TV
to the system (page 30) and select the “TV” function.
– Disable your TV’s speakers.
There is no sound from the
DIGITAL IN OPTICAL jack
(DAV-DZ510/DAV-DZ610/
DAV-DZ810 only).
• The sampling frequency of the input stream is more than 48 kHz.
There is no digital sound from
the HDMI OUT jack when using
the Audio Return Channel
function.
• Set [AUDIO RETURN CHANNEL] in [HDMI SETUP] to [AUTO] (page 73).
• Set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 72).
• Make sure that your TV is compatible with the Audio Return Channel function.
• Make sure that an HDMI cable is connected to a jack on your TV that is
compatible with the Audio Return Channel function.
• The sampling frequency of the input stream is more than 48 kHz.
The system does not output
sound correctly when connected
to a set-top box.
• Set [AUDIO RETURN CHANNEL] in [HDMI SETUP] to [OFF] (page 73).
Severe hum or noise is heard. • Move your TV away from the audio components.
• Clean the disc.
Symptom Problems and solutions