Sony GV-D200 VCR User Manual


 
40
Dubbing only desired scenes – Digital program editing
Setting the modes to cancel the recording pause on the other
(recording) VCR
(1) Turn the SEL/PUSH EXEC dial to select PAUSEMODE, then press the dial.
(2) Turn the SEL/PUSH EXEC dial to select the mode to cancel recording pause
on the other (recording) VCR, then press the dial.
The correct button depends on the other (recording) VCR.
Refer to the operating instructions of the other (recording) VCR.
The buttons to cancel recording pause on the other (recording) VCR
Select the buttons when you cancel recording pause on the other (recording) VCR, and
start recording.
The buttons vary depending on the other (recording) VCR. To cancel recording pause
• Select “PAUSE” if the button to cancel recording pause is X.
• Select “REC” if the button to cancel recording pause is z.
• Select “PB” if the button to cancel recording pause is N.
Setting your (playback) VCR and the other (recording) VCR to
face each other
Locate the infrared rays emitter of your (playback) VCR to face it towards the remote
sensor of the other (recording) VCR.
Set the devices more than 12 in. (30 cm) apart, and remove any obstacles between the
devices.
The other (recording) VCR
Remote sensor
Infrared rays emitter (back side)
1
2
ED I T SET
CONTROL
ADJ TEST
CUT - I N
CUT -OUT
I R SETUP
PAUSE
M
ODE
I R TEST
RETURN
[
MENU
]
:
END
PAUSE
REC
PB
OTHERS
ED I T SET
CONTROL
ADJ TEST
CUT - I N
CUT -OUT
I R SETUP
PAUSE
M
ODE
I R TEST
RETURN
[
MENU
]
:
END
PAUSE
OTHERS