Sony HDR-FX1000E DVR User Manual


 
50
EShutter speed
FWhite balance
appears during playback of the
movie recorded with the shot transition.
b Notes
• The exposure correction value (0EV), shutter
speed and iris will be displayed during viewing
of still images on “Memory Stick Duo.”
• Date and time will be displayed in the same area
when you select the date and time display. If
you record without setting date and time,
[-- -- ----] and [--:--:--] will be displayed.
• An accurate shutter speed may not be displayed
when you play back a tape recorded with your
camcorder on another device. Check the data
code that is displayed on the screen when you
play back the tape on your camcorder for the
accurate shutter speed.
• When you record a movie with the gain set to
[-6dB] and play it back with the data code, the
gain value is displayed as [---].
You can check the settings of the following
items.
• Audio setup such as [WIND] (p. 70)
• Output signal setup ([VCR HDV/DV], etc.)
(p. 74)
• Functions assigned to the ASSIGN buttons
(p. 41)
• Camera setup. (p. 63)
1 Press the STATUS CHECK button
C.
2 Turn the SEL/PUSH EXEC dial D
until a desired display shows up
on the screen.
When the POWER switch B is set to
CAMERA, the display changes in the
following sequence:
AUDIO t OUTPUT t ASSIGN t
CAMERA
When the POWER switch B is set to
VCR, the display changes in the
following sequence:
AUDIO t OUTPUT t ASSIGN
To hide the display
Press the STATUS CHECK button C.
Set the POWER switch to OFF (CHG), then
press the DISPLAY/BATT INFO button
E. The approximate recordable time in the
selected format and battery information
appear for about 7 seconds. You can view
the battery information for up to 20 seconds
by pressing the button again while the
information is displayed.
Displaying the settings in your
camcorder (Status check)
Checking the remaining battery
(Battery Info)
65
60
Remaining battery (approx.)
Recording capacity (approx.)
Changing/checking the settings in your camcorder (Continued)