Sony HDW-S2000P VCR User Manual


 
Chapter 10
Setup Menus
Chapter 10
Setup Menus 10-11
109
Item number Item name
Settings
FORCED EE WHEN
TAPE UNTHREAD
During tape threading and unthreading, and when no cassette is inserted, select
whether the setting of the function menu item PB/EE controls the PB/EE setting
for output signals.
OFF: Control by the function menu item PB/EE
[ON]: No control (always E-E signal)
111 TSO PLAY Select whether or not to enable tape speed override mode.
[DIS]: Disable tape speed override mode.
TSO: Enable tape speed override mode.
116 JOG DIAL RESPONSE Select the tape speed characteristics for the search dial rotation rate (VTR
commands).
[TYPE1]: Tape speed varies linearly over the range –1 to +1.
TYPE2: Tape speed varies stepwise as shown in figure
a)
below over the range –3
to +3. (Characterized by a zone around –1 and +1 where the tape speed is
independent of the search dial rotation rate. When playing back an HDCAM
tape, however, tape speed characteristic TYPE 4 applies.)
TYPE3: Tape speed varies linearly over the range –3 to +3, as shown in figure
b)
below.
TYPE4: Tape speed varies stepwise as shown in figure
c)
below over the range –2
to +2. (Characterized by a zone around –1 and +1 where the tape speed is
independent of the search dial rotation rate.)
117 CONTROL PANEL
SELECTION
Select the control panel function when the PANEL SELECT switch on the switch
panel is set to REAR.
[SW]: Only the control panel connected to the CONTROL PANEL connector on
the connector panel functions.
PARA : The control panels connected to the CONTROL PANEL connectors on
the switch panel and connector panel both function.
a) b) c)
+3
+1
-1
-3
FW
D
FWD
RVS
RVS
+2
+1
-1
-2
FW
D
FWD
RVS
RVS
+3
-3
FW
D
FWD
RVS
RVS
Speed
(reverse)
Rotation rate
TYPE 2 TYPE 3 TYPE 4
(Continued)
Speed Speed
Rotation rate Rotation rate
(forward)
Menu items in the range 100 to 199, relating to the control panels (Continued)