Sony HDW-S2000P VCR User Manual


 
Chapter 10
Setup Menus
Chapter 10
Setup Menus 10-27
Item number
Item name
Settings
801
DIGITAL JOG SOUND
Turns the digital jog sound on and off.
OFF: Digital jog sound is turned off.
Audio of digital channels not subjected to speed correction is output. When the
tape stops, after one second the audio is muted.
[ON]: Digital jog sound is turned on.
When the tape speed is in the range ×–1 to ×1 (for Betacam SX playback, in the
range ×–1 to ×2), speed correction is carried out, and the same jog sound as a
conventional analog VTR is output.
802 DIGITAL AUDIO MUTING
IN SHUTTLE MODE
Set the digital audio muting conditions during shuttle playback.
[OFF]: Not muted.
CUEUP: Muted during cue-up or preroll operations.
FULL: Muted in shuttle mode.
803 DIGITAL AUDIO FADE
TIME
Specify the time for cross-fade or fade in/out editing of audio signals.
5 ms, [10 ms] , 15 ms, 20 ms, 25 ms
a)
, 50 ms
b)
, 85 ms, 115 ms
c)
Note
The cross-fade or fade in/out operation means that the recording is rewritten from
the OUT point for the length specified by this setting. Even at the minimum 5 ms
setting, a length of recording corresponding to a field is rewritten.
To avoid rewriting, set menu item 317 AUDIO EDIT MODE to CUT. In this case
there is an audio discontinuity at the edit point. There is no effect on the recorded
video signal.
Menu items in the range 800 to 899, relating to audio control
805 AUDIO MONITOR
OUTPUT MIXING
Select the audio mixing method used for digital audio signals and Betacam
playback analog audio signals supplied to the MONITOR OUTPUT connector.
ADD: Simple addition
[RMS]: Root-mean-square
AVE: Simple average
806
LEVEL METER SCALE
Select the mode in which digital audio levels are displayed.
[PEAK0]: Displays the audio level as negative values with the maximum level set
to 0 dB.
REF.0: Displays the audio level as positive and negative values with the
reference level set to 0 dB.
a) Cross-fade time is 24 ms.
b) Actual value is 49 ms.
c) Actual value is 114 ms.
(Continued)