Filter
Top Products
Chapter 10
Setup Menus
Chapter 10
Setup Menus 10-17
Menu items in the range 300 to 399, relating to editing operations (Continued)
Menu items in the range 400 to 499, relating to preroll
Item number Item name
Settings
401
FUNCTION MODE
AFTER CUEUP
Select the state that the unit goes into after a cuing-up operation.
[STOP]: Stop (the “stop mode”)
STILL: Still playback (in search mode)
Note
When controlling this unit from an editor with the standard constants set, select
“STOP”.
402 TIME REFERENCE FOR
PREROLL
When prerolling a tape with time code discontinuities, select whether or not to use
CTL pulses to count time code from before a discontinuity.
[CTL]: Use CTL pulses to count time code.
TC: Do not use CTL pulses to count time code.
403 AUTOMATIC PREROLL
REFERENCE ENTRY
Select whether or not the edit IN point is automatically set by pressing the
PREROLL button, when the IN point is not set before starting preroll.
[DIS]: IN point is not set automatically.
ENA: IN point is set automatically.
405 CUEUP BY CTL Select the tape transport mode when cuing. This setting is valid only when the
function menu item CTL/TC is set to CTL.
[CAP.]: During cuing up, the tape transport is in the “pinch ON” state (maximum
tape speed 10 times normal).
REEL : During cuing up, the tape transport is in the “pinch OFF” state. As the
tape approaches the cue up point and the tape speed drops, the tape transport
switches to the “pinch ON” state.
a)
To give priority to editing accuracy, select “CAP”.
Item number Item name
Settings
334
EE REFERENCE
CONTROL
Specify how to select the reference video signal in E-E mode.
[NORMAL]: Select according to the table in Section 3-2-1 “Selecting Reference
Signal Depending on Operational Status”
(page 3-3)
.
INPUT: In E-E mode select the input video signal. When not in E-E mode, select
according to the table in Section 3-2-1 “Selecting Reference Signal Depending
on Operational Status”
(page 3-3)
.
336
EDIT PRESET INHIBIT IN
KEY PANEL CONTROL
Specify which buttons are disabled in the editing mode setting section on the
lower control panel.
[OFF]: Disable no buttons.
TC: Disable the TC button.
337 EXTERNAL REFERENCE
SELECT
Select the signal used when this unit is set up by setup menu item 309 and
F2(OUTREF) in function menu page 4 to use an external reference video signal.
[HD]: Use a high definition reference video signal. Input a three-valued (positive
and negative) sync signal to the REF.VIDEO INPUT connector.
SD: Use a reference video signal. Input a video signal with chroma burst (VBS) or
a monochrome video signal (VS) to the REF.VIDEO INPUT connector.
Note
When operating in 24PsF or 23.98PsF mode, the setting is HD and this item is not
displayed.
338
OUTPUT AUDIO/TC
PHASE
Set the audio (AES/EBU and analog) and time code output phase.
[HD]: Sync with HDSDI output phase.
SD: Sync with SD output phase.
Note
When operating in 24PsF or 23.98PsF mode, the setting is HD and this item is not
displayed.
a) When controlled from an editor (BVE-2000/9100 etc.),
selecting “REEL” allows high-speed cuing up.